Ibase FWA6504 User Manual

FWA6504 1U 19” Network Appliance Users Manual Version 1.0

FWA6504 User’s Manual 9 J4: VGA Header Signal Name Pin # Pin # Signal Name DACR 1 2 +5VCRT DACG 3 4 GND DACB 5 6 NC NC 7 8 CRT_SPD GND 9 10 HSYNC_

FWA6504 User’s Manual 10 LED5: Power, Alarm & Status LED Pin Header Signal Name Pin # Pin # Signal Name PWR LED+ A1 C1 PWR LED- ALARM LED+ A2 C2

FWA6504 User’s Manual 11 Chapter 4 Console Mode Information FWA6504 supports output information via Console in BIOS level. Prepare a computer as c

FWA6504 User’s Manual 12 4. Please make the port settings to Baud rate 115200, Parity None, Data bits 8, Stop bits 1 5. Power up FWA6504 and the

FWA6504 User’s Manual 13 Chapter 5 Opening the Chassis Fig. 5-1 Loosen6 screws on back, left and right sides Fig. 5-2 The system Chapter 6 Inst

FWA6504 User’s Manual 14 Chapter 8 Installing 2.5” SSD Fig. 8-1 Loosen two screws to remove left & right side brackets Fig. 8-2 Fasten bracke

FWA6504 User’s Manual 15 Chapter 9 Installing Mini PCI-e Module Fig. 9-1 Insert Mini PCI-e module (Supports USB signal only) Fig. 9-3 Release

FWA6504 User’s Manual 1 Table of Contents Chapter 1 Introduction ...

FWA6504 User’s Manual 2 Foreword Copyright© 2014 IBASE Technology INC. All Rights Reserved. No part of this manual, including the products and softw

FWA6504 User’s Manual 3 NO DISASSEMBLY The warranty does not apply to the products that have been disassembled by users Federal Communications Commi

FWA6504 User’s Manual 4 Chapter 1 Introduction The FWA6504 was specifically designed for the network security & management market. Network Sec

FWA6504 User’s Manual 5 Chapter 2 System Specification Product Description FWA6504 incorporates Intel® NM10 chipset. Currently, it is available in

FWA6504 User’s Manual 6 Chapter 3 Hardware Configuration Motherboard (MB837-1U) Layout

FWA6504 User’s Manual 7 The Jumpers JP1: Clear CMOS Contents Use JP1 to clear the CMOS contents. Note that the power connector or jack should be di

FWA6504 User’s Manual 8 The Connectors FAN1: System Fan Power Connector FAN1 is 4-pin header for System fan power. The fan must be a 12V fan. Pin #