Ibase SI-64 User Manual download pdf (Page 13)

IBASE Technology Inc.

2 HARDWARE INSTALLATION

2.1 Installing the CPU

To install the CPU, unlock first the socket by pressing the lever sideways, then lift

it up to a 90-degree. Then, position the CPU above the socket such that the CPU

corner aligns with the gold triangle matching the socket corner with a small triangle.

Carefully insert the CPU into the socket and push down the lever to secure the CPU.

Then, install the heat sink and fan.

NOTE:

Ensure that the CPU heat sink and the CPU top surface are in total contact to

avoid CPU overheating problem that would cause your system to hang or be

unstable.

2.2 Installing the Memory

The IB964 board supports four DDR3 memory socket for a maximum total memory of

32GB in DDR3 DIMM memory type.

Installing and Removing Memory Modules

To install the DDR3 modules, locate the memory slot on the board and perform the

following steps:

1. Hold the DDR3 module so that the key of the DDR3 module aligned with that on the

memory slot.

2. Gently push the DDR3 module in an upright position until the clips of the slot close to

hold the DDR3 module in place when the DDR3 module touches the bottom of the slot.

3. To remove the DDR3 module, press the clips with both hands.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 79 80

No comments

Ibase SI-64 User Manual Page 13